Watt Warming Indicator Lights Automatic

ZX Series Class D Monoblock Car Amplifier RMS Power Rating @ 4 Ohms: 750 watts x 1 chan. RMS Power Rating @ 2 ohms: 1500 watts x 1 chan. MOSFET power supply Wired remote bass level control included LED power and protection indicators Tuned Bass EQ (0-18 dB bass boost at 40 Hz) Balanced differential inputs make KICKER ZX Amplifiers compatible with any factory radios Eliminates unwanted noise in a system Boost, gain, and crossover frequencies are top-mounted for easy access, and a handy protection indicator featuring a new flashing yellow low-voltage light enhances the end panel Bridgeable operation Speaker-level inputs compatible (switchable) through RCA connection Preamp RCA outputs Automatic turn on modes: remote, DC offset, or signal sense Thermal, voltage, and short circuit protection circuitry Variable low-pass filter (50-200 Hz, 24 dB/octave) Subsonic Filter (24 dB at 25 Hz) CEA-2006 compliant amplifier Dimensions: 20"L x 9-5/8"W x 2-1/8"H

look up the cruchfield wire diagrams, and get a pair of kicker CVR 12's they are dual voice coil subs so youll have to get 2ohm subs and wire them to get 4 ohms per channel. just read the diagram for a Mono Amp DVC 2ohm 2 subwoofer setup. those kickers handle 400w rms per sub so it will be a pretty good match if you wire them right.

7 3/4inch W x 6 1/2inch H x 9inch D. Includes measuring cup and rice scoop.

Order at Amazon for $36.27

Details On My Subs: Nominal Input Power Rating: 600 W Cone Style: Cone Mounting Depth: 5.3 in Speaker Configuration: Single Speaker Diameter: 12 in Nominal Impedance: 4 ohm Cone Material: Polypropylene (Injection Molded) General Features: Gold-Plated Terminals Vented pole piece Magnet Weight: 42.3 oz Sensitivity: 93 dB Minimum Frequency Response: 25 Hz Maximum Frequency Response: 800 Hz Maximum Input Power Rating: 600 W Thunder TA Series Class D Monoblock Car Amplifier RMS Power Rating: 4 ohms: 150 watts x 1 chan. 2 ohms: 300 watts x 1 chan. Max power output: 300 watts x 1 chan. MOSFET power supply Wired remote bass level control included Thermal and short LED indicators Tuned Bass EQ (0-12 dB bass boost at 40 Hz) Adaptive Class D Technology: With MTX innovative approach, the amplifier’s switching energy is constantly changing and is moved away from FM radio frequency ranges as the amplifier’s load and output increases. Thermal and short protection StreetWires Connectors Xtant Technologies Cooling (XTC) thermal-regulated, turbo-charged intercooler Variable low-pass filter (at 80 or 120 Hz, 24 dB/octave) CEA-2006 compliant amplifier Dimensions: 12-11/16"L x 9-5/8"W x 2-1/2"H 4 or 8-gauge power and ground leads recommended. Contact us for information regarding a discount on a select amplifier kit when purchased together. 1-year Sonic Electronix warranty Monoblock Class A/B Amplifier with Bass Level Control RMS Power Ratings: 1 ohm: 600 watts x 1 channel 2 ohms: 300 watts x 1 channel 4 ohms: 150 watts x 1 channel Hifonics New Illuminated Heat-Sink Design With Blue LED Light Pumps Hifonics Blue Illuminated Logo Maxxsonics Illuminated "M" End Panel Logo Heavy-Duty Ultra-Fi" MOSFETS Highly Efficient Super D-Class Amplifier Circuitry With Oversized MOSFET Output Fully Adjustable Accu-Cross" Crossovers ±18dB Variable Bass Equalization @ 45Hz 180° Variable Phase Control (15 to 35Hz) Dash-Mountable Bass Remote Control Included Variable 24dB Subsonic Filter Brutus Pulse Wave Modulated MOSFET EXVP (Exponential Vari-Power Supply) Twin-Turbo Torroid Coil Design HSMD Hifonics Surface Mount Design Balance Line Inputs for our 18-Volt Line Drivers RCA Line Output for Amplifier Daisy Chaining Gold 4-Gauge Power Connectors Dimensions: 9.84"L x 10.39"W x 2.63"H 1-year Techronics.com warranty Kenwood KAC-8104D 1-Channel Car Audio Amplifier Power: 300 Watts x 1 @ 4 Ohm 500 Watts x 1 @ 2 Ohm MOSFET power supply LED power indicator Tuned Bass EQ (0-18 dB bass boost at 40 Hz) Speaker-level inputs with signal sensing for automatic turn-on) Preamp RCA outputs Short circuit, DC offset, overload, and thermal protection circuitry Aluminum die cast heat sink Built-in cooling fan Gold-plated RCA level inputs Gold-plated screw terminals Variable low-pass filter (50-200 Hz, 24 dB/octave) CEA-2006 compliant amplifier Frequency response: 5-200 Hz Subsonic Filter (15/25 Hz, 18 dB/ Octave) THD: 0.8% Dimensions: 11-1/16" Width x 2-3/8" Height x 9-7/8" Depth Kenwood KAC-8103D 1-Channel Car Audio Amplifier Class D Monoblock Amplifier Maximum Output Power: 1000 watts RMS Power Output: 300 watts x 1 channel @ 4 ohms 500 watts x 1 channel @ 2 ohms 2 ohm stable Frequency Response: 5 Hz-200 Hz Low-Pass Filter: 50 Hz-200 Hz, 24 dB/Octave Variable Input Sensitivity: 200 mV - 5 V Line Output Terminals for Extension Infrasonic Filter: 15 Hz, 25 Hz, 18 dB/Octave Bass Boost: 0-18 dB Fuse Rating 40A x 1 Signal-to-Noise Ratio 85 dB THD @ Rated RMS Power 1% Dimensions: 11-1/4" Length x 2-1/2" Height x 12-1/2" Width 1 Year Techronics Warranty! Kicker 06ZX300.1 1-Channel Car Audio Amplifier RMS Power: 150W x 1 @ 4 ohms RMS Power: 300W x 1 @ 2 ohms THD at 4-Ohm RMS Power: <1 % Speaker Level Inputs: Yes Preamp Outputs: Yes Built-In Crossovers: LP Bass Boost: 0 or 12 dB Frequency Response: 20-200 Hz Signal to Noise Ratio: 100 dB Advanced chassis with extruded aluminum heatsink MOSFET class A/B power supply Top-mounted controls Switchable KickBass 12 dB bass boost at 40 Hz 80 Hz low-pass crossover with 24 dB/octave slope Built-in 25 Hz subsonic filter High level or low level inputs (125mV-10V) PreAmp Signal Transfer (PAST) RCA outputs Delayed turn-off logic circuit Soft start turn-on circuit for reduced startup load Short circuit, Over-voltage, Reverse polarity, Thermal overload (SORT) protection 2 -Year Techronics.com Warranty Pioneer GM-7300M 800 Watts Monoblock Car Audio Amplifier800W Max, MonoBlock Amplifier RMS Power Output: 4 ohms: 250 watts x 1 channels RMS Power Output: 2 ohms: 360 watts x 1 channels PWM Regulated MOSFET Power Supply Screw-Type Speaker Terminals Balanced Isolator Input Circuit RCA Inputs Speaker Level Input Input Level Control Built-in Crossover Crossover Frequency Range: 40 Hz - 240 Hz Bass Level Control: 50 Hz Frequency Response: 10 Hz - 240 Hz Dimensions: 11-13/16"L x 13-1/8"W x 2-3/8"H 1-tear Techronics.com warranty

1 600watt so theres only 300 watts going to them that way they'll last longer because 12'' speakers have a trampoline effetc which over time can cause tearing if maxed out all the time.

Amp: ZX-Series 2-Channel Class A/B Amplifier Power Output 60 Watts RMS x 2 @ 4 Ohms 75 Watts RMS x 2 @ 2 Ohms 150 Watts RMS x 1 @ 4 Ohms Bridged MOSFET power supply Remote bass level input (remote level control sold separately) LED power and protection indicators Tuned Bass EQ (0-18 dB bass boost at 40 Hz) Balanced differential inputs make KICKER ZX Amplifiers compatible with any factory radios Eliminates unwanted noise in a system Boost, gain, and crossover frequencies are top-mounted for easy access, and a handy protection indicator featuring a new flashing yellow low-voltage light enhances the end panel Bridgeable operation Speaker-level inputs compatible (switchable) through RCA connection Preamp RCA outputs Automatic turn on modes: remote, DC offset, or signal sense Thermal, voltage, and short circuit protection circuitry Variable high-pass filter (50-200 Hz, 12 dB/octave) Variable low-pass filter (50-200 Hz, 12 dB/octave) CEA-2006 compliant amplifier Frequency response: 20-20000 Hz Dimensions: 10-1/4"L x 9-5/8"W x 2-1/8"H Speaker: 12" Comp series subwoofer. 4 Ohm Impedance 150 watts RMS / 300 watts Peak power Injection-molded polymineral cone Ultra length voice coil High temp voice coil former Rear cone brace Polyfoam ribbed surround - double stitched Marine ready Nickel Plated Terminals Frequency Response: 27-500 Hz Sensitivity 89.1dB and wat does sensitivity mean? is 89 any good? So it wouldnt hurt for me to get a 200 rms amp? and if i only want to push 1 12, does it matter whether my amp has 2 or 4 channels?

Yes, that amp will power it fine if you bridge it. Newer Kicker amp should come with a birth sheet. Their amps are very under-rated. My old ZX750 had a birth sheet of over 900W. And sensitivity is a measure of output at a given input level and distance. (how loud a speaker will play at a given wattage) EDIT: to the genius below me. Amplifier class is determined by it's efficiency and has nothing to do with its number of channels. By you saying that means that I could NOT use a Mono class D amp to power my front door speakers. Or a 2-Channel amp to power my sub(s). Wrong. Very wrong. We're talking 150RMS here. So efficiency doesn't have much play in this particular situation. Your information is very misleading to say the least. No it won't hurt to get a 200W amp nor will it matter if your using a 2-channel or mono. This george guy is hilarious. I've been reading his other answers. Then I see that he "knows more than the average car audio installer" yet he uses Crunch and Power Acoustik. Makes me chuckle.. Lol

Can u talk to somebody that has a CB radio with this KENWOOD TH F6 AT 144/220/440 Handheld Radio or not that has these features 144/220/440 MHz with 5 WATTS on all 3 bands 8 Character Alphanumeric Display Up to 8 groups of 50 channels per memory bank Famous Loud and Clear Kenwood Audio Dual Channel Simultaneous Receive even on the same band Easy access Single Knob Encoder/volume control 7.4 Volt 1550 mAh Lithium Ion battery (largest & most power in the industry) 4 Selectable Transmit Power Levels Backlit “laser-cut” keypad for durability MIL-STD 810 for vibration, shock and light rain Built-in CTCSS Encode/Decode / DCS Digital Coded Squelch 10 DTMF Auto-patch memories 1200/9600 bps TNC ready (no adapter required) Single High Performance Antenna (no switching required) AM Aircraft Receive TOT Time Out Timer Weight with PB-42L Battery 8.8 oz. First Ever Compact Amateur HT with Built-in VOX 435 PC Programmable Memories (over twice the competition) 3 Call Channels plus 20 for programmable scan Special (10) Channel Weather station mode Best HT ever for Satellite operation (including AO-27) FM/FM – W/FM – N/AM + USB & LSB / CW 0.01~ 1300 MHz RX (widest transceiver in the industry) Built-in battery charging system during DC operation Battery Voltage Level Indicator LARGE FONT mode for easy reading Multi-Scroll Key for easy menu access 1750 Hz Tone Burst Visual Scan to monitor adjacent channel activity Automatic Simplex Checker Built-in Ferrite Bar antenna for AM receive (0.1 ~ 7 MHz) Wireless Remote Control APO Auto Power Off Dimensions (W 2 5/26) x (H 3 7/16) x (D 1 3/16) inches

no, impossible as well as ILLEGAL. The TH F6 is an amateur radio, requires a FCC test and license to use. It cannot talk to anyone on CB